[Logic] Error in Logic 6.0

2002年4月20日 11:12:50 -0400

Steve,
 This is a problem with Fox pro & Microsoft> Dennis know of it
and I described this problem 3 months ago in LOGic 5.
Acording to Dennis Fox pro has a problem reading numbers above 65k.
I had hope there would be some kind of fix in LOGic 6.
Dennis subjested I turn off the "Edit Mode" for the 1010# look up. You
must
go into "Values Awards" under setup and turn off the 'Edit list' flag for
the
1010# field. This helps and the only problem I have on occasion is when I
get a number
not in the table. I have to add it to the list by hand or wait for an
updated 1010# list,
usually out by the end of the first week of each month.
Another problem you may run into is if you enter the a contact who is
portable with a
number. Like WB2JRI/5 OR KH6/WB2JRI, You must enter in the contact under
his regular
call and edit his portable statics after.
73
Tony WB2JRI
On 2002年4月20日 09:08:03 -0400 "Stephen J. Schrack"
<[email protected]> writes:
> I am experiencing a similar problem, but not quite the same. Mine 
> only
> happens when the 1010 number is a high number. In other words, The 
> 1010
> automatic lookup (or manual) works fine until the 1010 number 
> happens to
> be one of the higher numbers (60,000 or higher). Then I get the 
> error
> message described below. Sometimes I can recover from that though. I
> suspect it is a corruption of the 1010 list and was going to wait 
> and
> see if the next 1010.txt has the same issue. Perhaps the corruption
> takes place during import? My platform is WinXP Professional 384MB 
> RAM
> on a 1ghz workstation.
>> Best 73 de N3MX...STEVE
>> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]]
> On Behalf Of Roland Guidry
> Sent: Saturday, April 20, 2002 8:39 AM
> To: [email protected]
> Subject: [Logic] Error in Logic 6.0
>> I am have difficulty with this new program, Logic 6.0 Build 6.0.104.
> When my
> cursor passes over the userfield 1010#, I get an error as shown with 
> the
> attached gif pic. When I chose "no" the program exits and when
> restarted, I
> have to perform a clean then restart.
>> Sometime I get an error message that says "Invalid Subscript 
> Reference"
> Cancel or Ignore. If I "Ignore" program continues to run, if I 
> cancel I
> get
> other errors reported.
>> The file I downloaded for 1010#'s came from Win1010 using their 
> 1010.txt
> file. I do not have this problem with Logic 5.
>> Has anyone encountered this same problem. I email [email protected] on
> 4/18,
> no response to date.
>> Roland, WA5CHX
>>> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>>>> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic

73
Tony WB2JRI
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.