[Kenwood] Many misc Kenwood accessory items FS

Sat Sep 23 07:07:05 EDT 2006

Many misc Kenwood accessory items for sale:
Kenwood MC-48, touch tone microphone
Round, 8 pin connector, will go with any Kenwood rig 
taking this kind of connector (TM-201, TM-211, TM-221, 
TM-231, TM-241, TM-2530, TS-50, TS-430, TS-440, 
TS-570, TS-850, TS-870,TS-930, TS-940, TS-950, 
TW-4000, etc.). Has UP and DOWN switches and PTT, 
along with 16 digit touch tone pad. $ 50
Kenwood MC-46, touch tone microphone
Round, 6 pin connector, will go with any Kenwood rig 
taking this kind of connector (TR-7600, TR-7730, TR-7800, 
TR-7900, TR-8400, TR-9000, TR-9130,and others). Has 
UP and DOWN switches and PTT, along with 16 digit 
touch tone pad. $ 45
Kenwood MC-42 S hand microphone
This is the "standard" microphone that came with many
of the rigs such as the TS-430, TS-440, TS-930, and others
that take the round 8 pin mic connector that this one has 
on it. It has "up" and "down" switches, as well as the 
normal PTT switch. This particular MC-42 is in very nice 
condition. $ 35
Small Kenwood hand microphone
This is like the small hand mic that came with the
Kenwood TR-7400. It is a 500 ohm dynamic mic.
No model number on it, but it looks close to new, 
and works fine. If you like a smaller mic, compared
to the MC-35 or MC-30, this is it. 30ドル
Kenwood MJ-68 microphone connector adapter
Converts a round 6 pin Kenwood mic connector, so it can 
be plugged into a Kenwood rig with the round 8 pin 
connector. Like new. 20ドル
Kenwood MA-4000 duplexer
Combines (or splits) 2 meter and 440 MHz signals into a 
single coax cable. 2 m and 440 MHz connections are 
about 8 inches of coax with a PL-259 on the end. The 
common connection is an SO-239. In nice shape for 25ドル.
Kenwood TU-4 C
Subaudible (PL) encoder for Kenwood TW-4000
This unit provides separate tones for the VHF (2 m) portion 
and the UHF (440 MHz) portion. It plugs in to the TW-4000 
to provide the tones. No adjustments are normally needed.
This one is in its original box with paper work, hardware, etc.
60ドル
Kenwood PB-21 battery pack for TH-21 / 31 / 41 series HTs
This battery pack does not hold a charge well. Physically it is 
fine, but it needs a new "insert" in it. 15ドル 
Antenna adapter for Kenwood TH-21 / 31 / 41 HTs
This adapts the antenna connector found on these HTs to a 
standard BNC connector. 3ドル
Special Rubber Duck antennas for Kenwood TH-21 series HTs 
with the threaded connector
Aftermarket stubby, 3.3 inches long 10ドル
Kenwood RA-8 Stubby, 4 inches long 12ドル
Kenwood regular, 6.6 inches long 10ドル
Combo set of long 11.5 inch "gain" antenna and 4 inch stubby - 22ドル
Antenna adapter to fit the BNC connector on the HT and provide 
an SO-239 connector that will permit a PL-259 to be attached. 5ドル
Belt clip for TR-2400 HT, complete with hardware - 8ドル
Wrist strap - I think it fits most Kenwood (and maybe other) HTs - 4ドル
Battery charge cable for Kenwood TR-2400 HT
This is an adapter that permits one to charge the battery of the 
Kenwood TR-2400, 2 meter HT, outside of the HT itself. Usually, 
one must have the battery inside the HT, but this lets you charge 
a second battery outside of the HT. The original charger is used. 
It is in good shape, and works fine. 3ドル
Service manual for Kenwood TR-2600 HT - 10ドル
Service manual for Kenwood TW-4000 - 15ドル
Operators manual for Kenwood TW-4000 - 15ドル
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone (352) 732-8400