[Kenwood] Re: TX problems in Sub band

Sat Mar 11 17:55:22 EST 2006

If you're using the 13 pin ACC2 input on the back of the rig, I think you 
have to go into menu 50E and set that to "SUB" to get it to TX on the 
sub-band. I think the rig assumes you are using an external TNC when you put 
audio in through the ACC2 connector. 
The TS-2000 is a pretty neat rig- I'm on my 3rd one. The ARCP-2000 software 
allows you to design your own DSP equalization curves on both transmit and 
RX and load them into the rig, so there's almost no need for outboard 
processing equipment. If the TS2K had a slightly more robust front-end and 
an HF enabled sub-receiver, it would easily be the coolest radio ever made. 
Probably the most popular ever made, too. 
73,
Scott, N9AA 
Cyrus Turner writes: 
> Any body have an idea how I can get my new TS 2000 to transmit on the sub 
> band when going through the rear of the radio? I am running a Heil 
> Goldline pro to a DBX 286a into the back of the 2000 and when I switch to 
> the sub band it will not key the TX in the sub band. The PTT defaults back 
> to the main band.
> Cy/W5DXE 
>