[Kenwood] SM-230

2004年3月11日 21:24:58 -0800

Mike,
I belive the antenna (coax) connections are correct. As I can monitor
my transmit waveform on the scope.
As far as the connections from the scope to the radio, there is a
single 8 pin din conector on the back of the radio that says "scope"
there is a matching 8 pin conector on the back of the scope that says
"acc3" There was included with the equipment a cable that had a
attached lable that read "cable for sm-230 to ts-950" this cable is a
8 pin din on both ends. I can only "assume" that the cable would be
the one to use. BTW I tested the cable and it does ring out pin for
pin.
again thanks
John
----- Original Message ----- 
From: "M. Whiteman" <[email protected]>
To: "John Luthy" <[email protected]>
Sent: Thursday, March 11, 2004 7:29 PM
Subject: Re: [Kenwood] SM-230
> John;
> This might be a stupid question but I will ask anyways. Forgive me.
> You have the antenna from the 950 to the SM230 then to the
amp/antenna
> /whatever else is next?
> Secondly, you have a connector between the IF output of the 950 and
the IF
> input of the 230? Check for continuity of the IF cable or loose
ends. I
> assume that the radio receives signals OK.
>> 73
> Mike
>>> ----- Original Message -----
> From: "John Luthy" <[email protected]>
> To: <[email protected]>
> Sent: Thursday, March 11, 2004 11:40 AM
> Subject: [Kenwood] SM-230
>>> > Hello to the group,
> >
> > I have here a 950s and a SM 230 that I am trying to learn to use.
I
> > have been able to see the TX wave form and have seen the effects
of
> > improperly adjusted audio on the wave form. Very intersting. I am
> > having a bit of trouble using the band scope function, I have the
> > cable that goes between the radio and scope connected but I dont
seem
> > to be able to see recived signals. I suspect that my problem is
> > operator error. So what am I doing wrong?
> >
> > John
> > N7JL
> >
> > - - -
> >
> > Your moderator for this list is:
> > Larry Wilson KE1HZ [email protected]
> >
> > _______________________________________________
> > Kenwood mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/kenwood
> >
>>