[Kenwood] TS-850 INRAD 8.83 MHz Filter
Carlos Avellanet [kf4rrn]
[email protected]
2003年9月25日 07:41:09 -0500
You have to cut the two inner most pins of the connector block you are going
to align with the filter 3 pin side. Those are just ground pins and there
just for alignment purposes. It does not affect the operation of the radio
even with the factory filters. Make sure you snip the pins flush with the
connector block so that the filter sits flat and even. I wish I could scan
the instructions but my scanner is not working. I can fax them is you have
a fax number. INRAD would send you a copy free of charge but it would take
several days to get it.
Good luck, the TS-850 is an awesome radio.
Carlos. KF4RRN
> I acquire an INRAD 8.83 KHz filter from e-bay for TS-850. Filter has 3 pin
> one side and 5 on the other. But TS-850 filter holder has 5 pin on each
> side. Because of I don't have the installation papers I don't know what to
> do. Any experience ??
>> Thanks in advance
> Levent
>> - - -
>> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood
>