[Kenwood] 520 vfo
John Luthy
[email protected]
Sun, 4 May 2003 16:23:44 -0700
I have done this. It is easy.
there is nothing fancy here pin 1 to pin 1 pin 2 to pin 2 pin 3 to
pin 3 and so on and so on. I used a shielded wire for the VFO signal
but the rest was just plain old wire. I got a piece of 3 foot long
shrink wrap to cover the wires and the end result looked as good as it
worked. The most expensive part of the whole thing was the 3 foot long
piece of high tech super small sheilded wire. I probably didnt need to
use it but it made me feel better about the whole thing.
KF6QCQ
John
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Saturday, May 03, 2003 6:08 PM
Subject: [Kenwood] 520 vfo
> Need the wiring diagram TS 520 to VFO 520,I need to make a harness
> Thanks
> Dean
> KA6BGW
> - - -
>> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood