[Kenwood] TS-850S/AT Scan Problem
Guillermo
[email protected]
2002年6月25日 00:30:01 -0300
This may be a silly suggestion, but, the scan is always up or to low
frequency?, I think it may be a short or leak in up/down mic lines,
either in the rig or in the mike (in this case, unplug the mike to
verify).
Good luck
Guillermo -LU8EYW
Chad Johnson escribi�:
>> During yesterday's Field Day operation my KENWOOD TS-850S/AT commenced
> scanning without being told to do so. Once scanning started, I could not
> enter any other command, including CLEAR. The only solution was to turn the
> transceiver off. If I turned the transceiver on within a minute, the
> scanning continued. If I left it off for a couple of minutes the radio
> would work fine for a few more minutes then start scanning again. I reset
> the microprocessor but it did no good. I switched VFOs A and B but to no
> avail. I was using a DELCO VOYAGER Marine/RV deep cycle battery which
> measured 12.25 volts (receive mode) at the time. I have heard that the
> TS-850S likes to have a full 13 volts. Words of wisdom appreciated.
>> Chad W4CJ
> [email protected]
>> - - -
>> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood