[Kenwood] TS-850S/AT Scan Problem
Chad Johnson
Chad Johnson" <[email protected]
2002年6月24日 21:27:00 -0400
During yesterday's Field Day operation my KENWOOD TS-850S/AT commenced
scanning without being told to do so. Once scanning started, I could not
enter any other command, including CLEAR. The only solution was to turn the
transceiver off. If I turned the transceiver on within a minute, the
scanning continued. If I left it off for a couple of minutes the radio
would work fine for a few more minutes then start scanning again. I reset
the microprocessor but it did no good. I switched VFOs A and B but to no
avail. I was using a DELCO VOYAGER Marine/RV deep cycle battery which
measured 12.25 volts (receive mode) at the time. I have heard that the
TS-850S likes to have a full 13 volts. Words of wisdom appreciated.
Chad W4CJ
[email protected]