[Kenwood] Receive Problem in TS-120S
Guillermo
[email protected]
2002年6月19日 22:30:23 -0300
I've replaced one, but with two dpdt 12 v coil units in parallel.
Original was faulty with same symptoms, and not repairable after a few
prior fixes.
Good luck
Guillermo - LU8EYW.
"Dr. Gerald N. Johnson, electrical engineer" escribi�:
>> I had a Ts-120S that did that. I think I traced it to the multipole
> relay which I worked on repeatedly with Cramolin (Deoxit these days) and
> never did get it working well. Eventually I added a subminiature (HC-18
> size crystal can) relay to handle that section of the relay and it
> worked again. The multipole relay isn't available as far as I can find,
> it was special for the 120 and if its available its expensive.
>> 73, Jerry, K0CQ
> --
> Entire content copyright Dr. Gerald N. Johnson. Reproduction by
> permission only.
> - - -
>> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood