[Kenwood] Battery pack

2002年7月10日 15:30:57 -0400

First, before you go hammering on somnelthing like that, try a hair dryer. Often that simple heat will break the glue loose, and you wont damage the plastic etc. I would also take the whole shebang down to your local "Batteries R Us" type store. They often can replace almost any battery pack, and do it for a lot less money than radio stores do. I have had several different packs rebuilt by them, at a very cheap price.
"Dr. Gerald N. Johnson, electrical engineer" <[email protected]> wrote:
>I opened the case for my TH-27A battery. It was sealed with no screws
>but there's a visible seam. I used a small hammer (maybe 8 ounce) and a
>small vice as an anvil and tapped along the seam all the way around
>numerous times until I cracked the glue, then the case separated with a
>combination of screw driver prying in the crack and more tapping and
>flexing from the hammer taps. I found that the case was very snug to the
>nicad cells and one layer of Scotch #33 to hold things together before I
>assembled the case was almost too much to allow closing the case.
>There's a circuit breaker in the middle of the assembly to complicate
>the replacements of the cells. Replace the whole batch, maybe send the
>old lump with all its appurtenances of contacts and circuit breaker to a
>place that assembles custom battery packs, like Digi-Key and ask them to
>move the contacts and circuit breaker to the new pack. They can assemble
>the pack with welded straps that take a lot less room than the solder
>lugs.
>>73, Jerry, K0CQ
>-- 
>Entire content copyright Dr. Gerald N. Johnson. Reproduction by
>permission only.
>- - -
>>Your moderator for this list is:
>Larry Wilson KE1HZ [email protected]
>>_______________________________________________
>Kenwood mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/kenwood
>