[Dxbase] Fwd: EXTRA Info ---- Re: IC7300 CW-R

Thu Jun 1 14:56:36 EDT 2017

Hi All
Joe WA6AXE has been emailing me and has solved this CW-R issue
If you have an IC7300 and want to use CW-R then thank Joe!!
See the settings below
Many thanks to Joe again!
73 Fred
G4BWP
-------- Forwarded Message --------
Subject: 	EXTRA Info ---- Re: [Dxbase] IC7300 CW-R
Date: 	Thu, 1 Jun 2017 17:56:48 +0000
From: 	Joe WA6AXE <wa6axe at hotmail.com>
To: 	Fred Handscombe <fred at g4bwp.com>
Fred,
TRY this -- NOTE!! Since I do not have an IC-7300 -- I am only
taking a guess on this fix ...
In the Radios.ini file for
[ICOM_IC-7300_SPLITOK]
CHANGE the following entry from
P_CWR=3
to read
P_CWR=7
THEN - CHANGE the following entry from
CWR=3
to read
CWR=7
THEN - CHANGE the following entry from
DefaultCWR=3
to read
DefaultCWR=7
Then SAVE your Radios.ini file and execute DXbase2007 again and
this time - try to log CW-R
Fred --- In DXbase2007 Radios.ini file -- if the MODE is NOT part of what
DXbase was built-around .. We normally set that mode to ZERO ..
But, for the sake of CW versus CW-R -- ICOM has CW as a 3 and CW-R as a 7
And,. since DXbase2007 doesn't have a CW-R -- I am NOT too sure that
the above mentioned FIX will even work...
You might ask Neal for some assistance on this also!!
73 Joe wa6axe