[Dxbase] Fw: Serial port problem

Mon May 2 17:07:53 EDT 2016

Never mind.
Just a few minutes after I sent the note below I found the check box that says to read the frequency from the radio.
Problem solved.
73 Tom N4TL

----- Forwarded Message -----
 From: Tom Lewis <n4tl2 at yahoo.com>
 To: DXBase List <dxbase at mailman.qth.net> 
 Sent: Monday, May 2, 2016 5:03 PM
 Subject: Serial port problem

The power went off for a few hours yesterday. The UPS keep my logging computer running for a while but not as long as usual. DXbase was not shutdown correctly. When I powered it back on and ran DXbase the columns were not correct for many windows and I had to un-hide many. There were many other issues so I finally uninstalled and reinstall DXbase. Now all the windows are correct and my log looks okay. The problem I can't fix is that DXbase does not read the frequency of the radio correctly. The serial port is set to 19200, N81 the same as it was. I have the same Icom 7600 configuration file being used. DXbase will set the frequency of the radio okay, but when it reads it, it has 47GHz.  
I checked the operation of the radio with the N1MM contesting program. That program reads and writes the frequency correctly.
Does anyone have any ideas on what I can check?
I will be buying a new UPS battery. 
ThanksTom, N4TL