[Dxbase] DXBase 2007 V 1.10 Registration Problem

Sat Jul 18 13:41:55 EDT 2015

 Mark,
You have to MODIFY your 32 bit reg file to a 64 bit reg file .. Here are
the instructions:
Converting a 32bit Registration file to 64bit.
Use notepad to open the registration file that you have for 32 bit.
Replace the following line:
[HKEY_LOCAL_MACHINE\Software\Scientific Solutions\Dxb2007]
With the following line:
[HKEY_LOCAL_MACHINE\Software\Wow6432Node\Scientific Solutions\Dxb2007]
Save changes to a new filename so that you do not erase your
original 32bit registration.
To apply this new registration, double click the .reg filename.
73 Joe 

On 07/18/15, Mark Hammond wrote:
Hello All: 
I just upgraded my Ham Radio computers and decided to run the Windows 7 64b it version on them instead of the 32bit version that I had been using on my older computers. All went we ll with the installation of DXBase 2007 V 1.10, Â except that when I applied my Registration Code, it did not take. It still says that I need to apply the code to register the product . Has anyone else encountered this problem ? Or is there something else that I need to do to make the registration work? I think I remember some email s about registration, but I can"t find them... 
Thanks in advance for your help. 
73, Mark K7HPH
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html