[Dxbase] MixW Bridge does not work

Wed May 14 19:00:17 EDT 2014

 Let's TRY this again...
Halvard,
I am the author of the MixWBridge and if you have a Windows7 64 bit O/S and if
you have DXbase2007 ver 1.10 installed right off of C:\ drive -- 
(1) Make sure that YOU have SETUP your new install OPTIONS / 
General TAB .. DXBPsk Interface area -- Checkmark AUTO SAVE QSO
(2) The one thing that I just ran into on my Win7 64bit laptop - was that I
MUST go into the
MixWBridge.exe
program file Properties -- and under the Compatability TAB
In the Compatability mode area -- ""CHECKMARK"" the following and select for:
Run this program in Compatability mode for:
Windows XP (Service Pack 3)
THEN CHECKMARK also
Run this program as an adminstrator
NOW -- press apply -- then press ok..
This should make it work --- the above steps just now HELPED ME get MixW to log directly
to DXbase2007 ver 1.10 using MY MixWBridge ...
GL!!
Joe wa6axe

On 05/14/14, Halvard Eriksen<hal-erik at online.no> wrote:

I just updated my DxBase2007 from ver.1.06 to 1.10 an MixW Bridge does 
not work any more.
When I save a QSO in MixW it is no longer saved in DxBase. This worked 
fine with DxBase v1.06
My MixW is ver. 3.01 and has not been changed.
Does anyone have a solution?
73 de Halvard, LA7XK
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html