[Dxbase] Label Designer in DXBase2007 v1.10

Fri Nov 16 10:35:27 EST 2012

Gert,
When you open the label/card file -- be sure that you are specifying
the correct number of DATA lines that are on the label/card --
When the small window (entitled: Select Label Type) opens,
be sure that you fill-in the "QSOs Per Label" with the correct info.
If the file has THREE lines of data (max that it can handle) - then
type in "QSOs Per Label" = 3
73 Joe WA6AXE
> From: pa3aav at hetnet.nl
> To: Dxbase at mailman.qth.net
> Date: 2012年11月16日 14:50:06 +0000
> Subject: [Dxbase] Label Designer in DXBase2007 v1.10
>> I recently switched from DXBase2007 to DXbase2007 v1.10 
> In DXbase v1.10 the Label Designer is different from the one in DXbase 2007.
> The new label design program does not recognise a design made with the old label designer regarding printing multiple QSO 's on one QSL card.
> It "accepts" the first QSO line but not the following lines.
> The error message generated says: Syntax error: cannot interpret term MODE2, it says this for all the folowing fields from the oher QSO lines.
> Anyone else noticed this ?
> Any solutions?
>> Thanks,
>> Gert, PA3AAV 
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html