[Dxbase] Telnet Indicators

Thu Jan 12 13:19:17 EST 2012

Looks like Yahoo is up to its old tricks. Post this over there @ 9:39 and
it's still not showing up.

And after a bit of research J

I downloaded VE7CC CC User and installed it.
Followed directions for set up.
In the Set menu click all the LoTW items (Show LoTW, Auto Updater, LoTW
Checker)
In the configuration menu go to Ports
There is a section called Logging Program Connection
Enable Telnet
Click use port 7300
Save

Open DXBase
Tools 
Options
User Options
Telnet
IP host select 127.0.0.1:7300 # Localhost <- this might say aruser or
ccuser or localhost, it doesn't matter, anything after the # is a comment.
Then click OK

Depending on if you are already connected somewhere else or not it's best to
just close the Internet Cluster window and then go to Window in the menu bar
at the top of DXBase and open New Internet Cluster.

I think you need to keep the CC User active but minimized. DXbase is
gathering it's info from that program. The + will show up in DXBase just
before the time stamp.

Success! 

I suspect it's the same for using AR user.

Greg
NZ6E