[Dxbase] previous qsos problem

Wed Aug 8 22:24:20 EDT 2012

Just a shot in the dark here...
Open the Previous QSOs window and click the box next to Select Field Order. 
Now close the window and then reopen it again. A window will pop up titled 
"Previous QSO Configuration Path". The box will have the path to the 
current configuration file in use. Now click on the little box with "..." 
in it and look in the folder where this configuration file is located. Is 
this the correct path? Is there another configuration file there with a 
different name that may have been created some other time? If, try 
selecting it and see if that shows the RSTs and RSTr information. When done 
clear the check box.
73,
Gary AL9A
----- Original Message ----- 
From: "PAUL" <K8PO at ROADRUNNER.COM>
To: <dxbase at mailman.qth.net>
Sent: August 08, 2012 4:32 PM
Subject: [Dxbase] previous qsos problem
> Hi all, attached is a screen shot that illustrates the issue. As you may
> see, the log shows RSTs and RSTr but the Previous QSOs screen does not.
>>>>>> Again, any possible help appreciated. 73, Paul
>>>>
--------------------------------------------------------------------------------
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html