[Dxbase] localhost

Fri Sep 16 16:25:41 EDT 2011

Ben,
In CC User click on Configuration/Ports/Logging Program and check the "Node 
Connection" settings. Click on Telnet and set the TNC Port Settings to 8, 
N, 1 Hardware. Now check the area of the window titled "Logging Program 
Connection". Make sure "Enable Telnet" is checked and the radio button for 
"Use Port 7300" is also checked. Click on the Apply button.
I have DXB2006, but in my Host file I have an entry of "127.0.0.1:7300 # 
localhost CC User". Note the 7300 after the colon. That is the port that 
CC User will send spots to in your logging program. This port also needs to 
be identified in the Host file for the connection to work.
73,
Gary AL9A
----- Original Message ----- 
From: "KB1FJ" <KB1FJ at COMCAST.NET>
To: <dxbase at mailman.qth.net>
Sent: September 16, 2011 11:54 AM
Subject: [Dxbase] localhost
> Still not working properly.
>>>> My c:\Dbase2007\Hosts file has the following in it. ( 127.0.0.1 #
> Localhost ) I entered this as the last entry, by opening modify host 
> file
> in the file dropdown menu. I click on OK.
>>>> I then opened user options\internet, found the localhost entry I just 
> placed
> in the Host file and click on OK.
>>>> I then opened VE7CC user program. Everything looks good so far.
>>>> I go back to Window/New Internet Cluster and got the error message 'could
> not connect to the site!'
>>>> Where did I go wrong? Anybody know?
>>>> Thanks,
>>>> Ben, KB1FJ
>> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html