[Dxbase] Fwd: cw regedit code dxbase7 registred

Tue Dec 1 12:32:51 EST 2009

Does anyone have any advice for Paul? I am not so sure what the problem is
so am asking for your help!
73
Neal Campbell
Abroham Neal Software
www.abrohamnealsoftware.com
(540) 242 0911
Amateur Radio: K3NC
Blog: http://www.abrohamnealsoftware.com/blog/
DXBase bug reports: email to cases at dxbase.fogbugz.com
Abroham Neal forums: http:/www.abrohamnealsoftware.com/community/
---------- Forwarded message ----------
From: <f5qe at aol.com>
Date: Tue, Dec 1, 2009 at 5:23 PM
Subject: cw regedit code dxbase7 registred
To: support at abrohamnealsoftware.com
hi dear Sir,
quick V 1.04.. cw trouble after a fews days because windowsxp,
 dxbase corrrupt by a loading program ??? I dont know ??
I use com1 original com from mother board..3f8 cw keyer... internal dxbase
........... all ok with others sw mixwin etc etc..
I think the port com is dont'open by the dxbase... If open it by a other sw
on the com1...........the cw out is good!!
on the regedit............all code is the same of your specs... ONLY
 Ignore conflits are 0x00000000 not 00000001
port base is good 3f8
portcount is good 7
please where is the trouble ??? of course I modified 0 to 1 but the
trouble are alsway here ... no cw output
NB CAT RUN COM 2 but the CAT lcd front panel of my 1000mp is only active
with a dx click after... no flash.
for me is right ??
your opinion please
MERCI 73 PAUL F5QE