[Dxbase] Omni 6(+) with DXbase

Sat Nov 22 00:33:22 EST 2008

GM all
I have just connected up an Omni 6 that has upgrade Options 1, 2 and 3 installed whichmakes it all but and Omni 6+.
I am using a Microham microkeyer as the interface. The Omni 6 talks to the Microham router SW OK, and works perfectly (control in both directions ) with Wintest.
I cannot get it to log the frequency or QSY to DXspots with DXbase. When slectthe radio settinsg and OKit there is a short delay and then back to "normal" whoch indiactes I think that DXbase is recognisingthe rig, but will not control it for some reason
The Microham works fine with an Icom 756Pro3, worked oK with an Orion and FT1000Mk5 previosuly.
Anyone using an Omni 6(+) out there? I would appreciate some help!
73 Fred
G4BWP
http://sites.google.com/site/fhandsc/Home
http://fhandscombe.googlepages.com
NB Not the newer Omni 7! I have one of those too and it wont talk "properly" either, DXabse does most times read the frequency. Again 100% Ok in Wintest and N1MM.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/dxbase/attachments/20081122/3352130a/attachment.htm