[Dxbase] VISTA and DXb 2006

Tue Jul 22 07:23:18 EDT 2008

OK Jack - all working now
I was using the 2004 .REG file so I simply exported the Registery entry from
my previous notebook as VE3SY.reg to a shared directory on my new Dell. I
ran the new .REG file and it installed itself in VISTA.
Thanks for suggesting too check the .REG file 
73
Paul VE3SY
-----Original Message-----
From: Jack [mailto:jack at dxbase.com] 
Sent: July-22-08 5:53 AM
To: Paul Cassel
Subject: Re: [Dxbase] VISTA and DXb 2006
Paul,
Are you actually using the correct registration file for DXbase 2006? We 
have had reports like yours where the user says they did everything 
correctly, got the correct response indicating that the registry was 
updated, but still the program stayed in trial mode. In every case, it 
turned out that the user was using an old registration file for the wrong 
version.
I am assuming you are not using 64bit Vista.
Regards,
Jack
----- Original Message ----- 
From: "Paul Cassel" <paul at ve3sy.com>
To: "'DXbase'" <dxbase at mailman.qth.net>
Sent: Monday, July 21, 2008 8:22 PM
Subject: [Dxbase] VISTA and DXb 2006
>I have not seen any feedback relative to VISTA and DXB 2006 other than from
> Gary AL9A who has the identical Dell Notebook and reported all OK
>>>> * I was logged in as Admin
> * I right clicked on the Set-Up and selected Run as Administrator
> * DXB loaded and ran fine in Demo Mode
> * I then ran the CALL.REG registration key and replied to the Anal
> Vista warnings and it reported that the registry was updated
> * Started DXB and it still indicates not registered.
>>>> Any suggestions guys? The reference in the archives to 64 bit does not
> match my registry layout and so I assume it is not applicable?
>>>> Paul VE3SY
>> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>