[Dxbase] DXbase and IC-746Pro

Mon Sep 3 16:11:55 EDT 2007

I was using this function with IC-746 for last 2 years with no problem,
with ANY baud rate...till today. You can call it a miracle, but TODAY it
stopped working. Exactly the same way as couple of months ago the internal
CW engine "died". 
 I've checked the settings, connections, rebooted the PC,
transceiver...Nothing.
 And the same story as yours: both CT17 and keying interface still working
with other programs and same IC-746 (non-PRO).
73! Ilya 4Z1UF
-----Original Message-----
From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net]
On Behalf Of Joe Gore
Sent: Monday, September 03, 2007 4:16 PM
To: dxbase at mailman.qth.net
Subject: [Dxbase] DXbase and IC-746Pro
I have just switched from a Kenwood radio to the IC-746Pro. DXbase will get
the radio information (freq, mode) when I manually put the callsign in the
log, but if I click on a spot, nothing happens except that I get the "not
responding" message.
My interface works with N1MM Logger, Ham Radio Deluxe and Amateur Contact
Log just fine. I have tried different combinations of port, speed,
DTR/RTS/CTS, etc. The initial pacing value in radios.ini was 8, but I've
tried 15 and 50 as well.
Can anyone help with this problem?
73,
Joe
WA4RTE
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net