[Dxbase] Rotor Control

Sat Nov 17 14:36:39 EST 2007

I have a two rotor setup, using a Yaesu G-2800DXA for rotor 1 and a Yaesu
G-800XA for rotor 2. Both rotors are computer interfaced using Idom Press
controller boards. I use a Byterunner USB to serial port computer interface
to obtain the necessary number of serial ports.
Computer control of rotor 1 via DXBase always works flawlessly. My problem
is with rotor 2.
When I first set up rotor 2 in user options, it too works flawlessly as long
as I don't use rotor 1. After the first time I control rotor 1 through
DXBase, rotor 2 will no longer function through the DXBase interface.
If I then deactivate rotor 2 in DXBase user options, close user options,
reopen user options and then reactivate rotor 2, it will once again function
flawlessly - but only until I use rotor 1 again. Then rotor 2 is non
functional.
Any ideas of what my problem might be?
Thank you,
Ken W8LU