[Dxbase] Need some help...

Mon Jul 30 14:45:55 EDT 2007

I purchased a cable from G4ZLP to run my ICOM IC-756PROII so as to 
have the use of the keyboard CW from DXBase. I installed the legacy 
driver and have gone through the help files many times and find I 
still must have something set up wrong. It runs the frequency 
control and everything just fine, but the CW does nothing. The cable 
is on serial port 1 and I have RTS High and CTS both checked and DTR 
High is not checked. If I check DTR High the radio just keys up and 
stays keyed until I un check it. This gives me a clue that the cable 
is connected correctly but have the feeling that I have missed 
something. Help would be appreciated.
Also it appears that the AR-cluster Reflector has me locked out to 
send messages, so I thought I should put out the information that I 
have replaced my AR-Cluster Node with CC Cluster, (Faster and Better 
anyway). My connection to the node is still the same, k8smc.com or 
IP address 69.2.20.5 standard port 23.
Terry, K8SMC . . .