[Dxbase] Icom radio control and DXBASE 2007

Sun Dec 24 16:54:53 EST 2006

<< no problem retrieving information from the rig
What does this mean? With what program?
<< when I switch to dxbase 2007, I get nothing
Be sure to check the wiring of your circuit to see how the CI-V gets it's
power. Many get power from the RS-232 handshake pins. Once you've found
out which one, play with DTR High, CTS High etc, settings under Tools -->
Options --> User Options --> Radio1.
Also be sure to check "Connect HF1 Radio 1 Interface"
Michael K3KH
-----Original Message-----
From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net]
On Behalf Of Esteban Romagni
Sent: Sunday, December 24, 2006 11:01 AM
To: dxbase at mailman.qth.net
Subject: [Dxbase] Icom radio control and DXBASE 2007
Hello all,
I made over the weekend a new civ interface (from the AA8DX article in Feb
1993 QST); when I use N1MM, no problem retrieving information from the rig,
when I switch to dxbase 2007, I get nothing (using icom 756PRO III, 1200
baud, dtr high, word l. 0, parity none, stop bits 2.)
When I do a quick test under tools, set hf frequency, if I spin the dial and
do retrieve, I get info (the wrong info at times). My settings in the rig
are baud 1200, civ address 5ch.
Is there is anything I should tweak inside radio.ini?
Any suggestions are welcome...
Steve
W4DTA
 
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net