[Dxbase] Radio Control "Problem"

Sat Apr 22 14:35:43 EDT 2006

I have had this happen quite a bit lately. First, the "old days". The HF
rig could be on or off when I started DXBase (2006). Normally it would
start up with no problems. If I didn't have the HF rig on DXB didn't seem
to care unless I tried to tell DXB to do something with the rig such as
change to a DX spot. If the rig was off then DXB would say that it was off
and turn off the communication between the program and the rig.
Recently I get the communication error if the rig is on or off when I start
the program. I haven't made any changes to the computer lately except
replace the power supply.
Any ideas or clues?
Bob
KB4CL