[Dxbase] Add new callsign?

Sun Feb 27 07:57:50 EST 2005

First off you need to have each callsign your going to put into DXB included in the 
'Registration' file you request from Jack.
That allows you to enter qso's where the operator would be AE9B/0
Now for non-USA logs. You must again request that particular callsign be included in the 
'Registration' file.
BUT...
I strongly suggest you make a separate .mdb file for those logs.
My reasons are for DXCC and other awards, AE9B and AE9B/0 qso's will be acceptable.
The qso's and countries worked as PJ2 are not.
A 'Registration' file can contain up to 10 callsigns.
In my log, I have WN9VOL, WA9VOL, & W9OL.
You send Jack an email and ask for the various calls to be included in the 'Reg' file and 
they will send it back.
STORE IT IN A SAFE PLACE.
----- Original Message ----- 
From: "Tom Baugh" <tbaugh at kcweb.net>
To: <dxbase at mailman.qth.net>
Sent: Sunday, February 27, 2005 5:24 AM
Subject: [Dxbase] Add new callsign?
> How do I set up a 2nd or 3rd callsign?
> I will be traveling down to PJ2 for the 4th time and have a log of PJ2/AE9B
> I also have a log of AE9B/0 for a variety of operations.
> What is the protocol to get these callsigns setup?
>> Tom
> AE9B
>> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>