[Dxbase] ICOM 756 Pro question

Sat Feb 19 08:25:56 EST 2005

The PROII and the original PRO use different default (hex) addresses, but
they are changeable in both DXbase and the radio. I think the PRO is 5C,
and the PROII is 64. N5IN is the expert at Icom settings in the radios.ini
file. The important consideration is that the address in the radios.ini
file and the radio must be the same.
For my PROII, I'm using 19200/N/8/1.
The setting for DTR/RTS/CTS varies with the type of interface. For my K1NU
cable/interface, I need RTS high. For my RIGblaster Pro, which I used
previously, none of those is checked. I don't have the expensive ICOM CIV
unit.
Jim N7US
-----Original Message-----
From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net]
On Behalf Of Brent
Sent: Friday, February 18, 2005 10:19 PM
To: dxbase at mailman.qth.net
Cc: daditda at comcast.net
Subject: Re: [Dxbase] ICOM 756 Pro question
Jack,
This is what I have setup for my ProII which should be the same.
CI-V Baud Rate 19200
CI-V Address 64h
CI-V Transceive On
CI-V with Ic-731 Off
In DXbase I have
com1, 19200 8,N,1 and DTR and RTS are checked.
Hope that helps you.
-Brent N9BC
www.hamshacks.com
----- Original Message ----- 
From: "Jack" <jack at dxbase.com>
To: <dxbase at mailman.qth.net>
Cc: <daditda at comcast.net>
Sent: Friday, February 18, 2005 5:24 PM
Subject: [Dxbase] ICOM 756 Pro question
> Anyone got one of these who can tell me what radio options to set in
> DXbase. Also, what address should be in the radio.
>> Got someone having difficulty and not sure what to do. His radio 
> reports
> it is using 64H but that seems wrong to me???
>> TIA
>> Jack
>> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net