[Dxbase] can not connect Internet cluster

Sat Dec 3 22:21:05 EST 2005

Toshi
I'm not sure exactly what your doing.
But....
192.168.1.20:7300 is usually an IP from a router.
If you wish to connect to a cluster than you should use that cluster's IP directly.
In Tools>Options>User Options click on Internet.
Then where it says IP Host, choose the cluster you wish to connect with.
If the cluster you want to use is not listed, than you must use File>Modify Host File and 
enter it.
Hope this is what you were asking about.
----- Original Message ----- 
From: "Toshimi Horie" <je2uff at dxer.cc>
To: <Dxbase at mailman.qth.net>
Sent: Saturday, December 03, 2005 7:47 PM
Subject: [Dxbase] can not connect Internet cluster
> Hi all.
>> My name is toshi, can use DXBase2006. It is nice sw. But now I have
> one problem in this software setting.
>> Now running DX-spider software in my local network. It can use DDNS.
> so outside my network, can use domain. but inside.normaly use private
> address. one exsample, I can use RXCLUS then set up node address was
> 192.168.1.20 and port was 7300. It can connect DX-Spider from RXCLUS.
>> But DXBase 2006 was same setting, host file modificated (add local IP)
> wrote as follows 192.168.1.20:7300
> but can not connect local DX-Spider host, DXBase2006as show
> "could not connect this site"
>> Why other software (DX-telnet, RXCLUS,windows-telnet,etc) can connect
> host, Why can not connect DXBase2006.
>> Who's know this countermager. Please tell me aonther set up.
>> -- 
> Toshimi Horie <je2uff at dxer.cc>
>> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>