[Dxbase] The case of the missing toolbar

Sun Nov 21 12:36:02 EST 2004

After huntina all over the screen, I concluded that my Internet toolbar
had "vanished". I found a help section about this problem but, not
being particularly computer intuitive, I thought I better check before I
start deleting lots of lines of code.
As the help section said, I found a Dxb2005 file in my Windows list. It
was not identified as an ".ini" file but was listed as a "Configuration
settings" type. I found a bunch of code that started with a line:
"(DTBarState-Summary)". It had about eight lines after it. Next, I
found "(DTBarState- ToolBar Management)" with some more lines aafter
that. Then it went into "(DTBarState-Bar 1)" followed by about 15 lines
of code with lines like "Bar#01"."MRU=...", etc. This went on all the
way up to "(DTBarState-Bar 13)". 
My question is do I erase all of those lines of info, e.g. over 200
lines of code? As I read the Help seciton that is what I should do but
my finger gets queezy when I think of all that code going away.
Tns & 73,
Dennis, K2Sx 