[DXBase] ICOM 758ProII
Oystein Stokkeland
[email protected]
2004年3月23日 07:32:38 +0100
Do you mean that there are any functional difference in the way DXbase
controls the PRO and PROII ??
=20
73 de
=20
=D8ystein Stokkeland LA7QI
Tel: +47 51 67 70 97 / +47 971 56 090
email: [email protected]
*****Representant i Norge for DXbase logging program*****
=20
-----Original Message-----
From: [email protected] [mailto:[email protected]] =
On
Behalf Of Ron Stordahl
Sent: 21. mars 2004 16:34
To: [email protected]
Subject: Re: [DXBase] ICOM 758ProII
There have been some recent questions about computer control of the Icom
756Pro and Pro II.=20
Here are the settings which are successful for me:
While I have the Pro II I use the Pro address. This is because at one =
time
WriteLog did not have a selection option for the Pro II, thus I set my =
Pro
II interface address at '5C' so it would be addressable as a Pro, and I =
have
never changed it back.
In DXBase2004 I have the software options set as:
Icom IC-756PRO
COM1 (although it also works with all my 10 com ports resulting from =
the
installation of 2 Byterunner 4 port PCI cards)
19200/8/1 (also works fine at 9600, but this seems just a tad faster)
Parity NONE DTR HIGH (Actually works just as well with this unchecked)
In the radio I have these settings:
CI-V Baud Rate 19200
CI-V Address 5ch
CI-V Transceive ON
CI-V w/IC731 OFF
I am using the ICOM CT-17.
I have it connected to the computer with an off the shelf DB9 to DB25 =
Modem
cable. This cable connects all 9 pins from the DB9 to the appropriate =
pins
on the DB25, plus shield. This cable is overkill, probably only 3 wire
would need to be run, but it was available prebuilt, so I used it.
Ron N5IN
_______________________________________________
DXBase Reflector - Please visit us on the web at www.dxbase.com
- - - - - - - - - - - - - - - - - - - - - - - To UNSUBSCRIBE please =
visit:
http://mailman.qth.net/mailman/listinfo/dxbase