[DXBase] Serial to USB cable (from VR2GA)

2004年1月28日 08:51:56 -0600

thanks for the update Ed.
Been so long since I had anything other than Yaesu that I didn't remember that.
But then I can't remember what I had for breakfast, and I'm still eating it.....
----- Original Message ----- 
From: "Ed Parish K1EP" <[email protected]>
To: "FireBrick" <[email protected]>; <[email protected]>; <[email protected]>
Sent: Wednesday, January 28, 2004 8:27 AM
Subject: Re: [DXBase] Serial to USB cable (from VR2GA)
> At 1/28/04 07:33 AM, FireBrick wrote:
> >Normally, USB to serial adapters are tolerant of baud, and stop bit discrepancies, but
> >make sure that if yours allows changes to set it to the 4800, 2 stop bits, required by
> >most rigs, (not sure what the Kenwood requires).
>> I only know of the Yaesu radios that require this, especially the 2 stops bits. I would
not recommend using 2 stop bits unless your radio specifically requires it, as does the
Yaesu. Other radios have configurable speeds. I have used some radios up to 19,200.
>>> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase
>>