[DXBase] Elecraft K2

2003年10月04日 17:21:19 +0100

HI Dan,
 Can you give us a little more information on your setup?
For the k2 you want to set the serial port for 4800 Baud, Parity 
NONE. Word Length 8 bits, 1 Stop Bits,
Make sure that connect HF radio serial interface is checked
DTR High and RTS high settings don't matter for the K2 as it does not use 
them (which in theory means that you can use a keying interface on the same 
serial port as the K2 although I have never tried this )
Dxbase needs exclusive access to the serial Port (I.e you cannot run K2 
remote at the same time)
I did the support file for the K2 in DXbase 2004 so please tell me about 
any errors you find with the K2 support in Dxbase2004
73
Brendan EI6IZ
At 16:55 04/10/2003, Dan Copeland wrote:
>I just installed DXBASE 2004 and everything works great except
>the radio control. I have a K2 and it works with the program
>from Elecraft just fine. Does anyone know what I should do?
>>Dan N0DT
>>_______________________________________________
>DXBase Reflector - Please visit us on the web at www.dxbase.com
>- - - - - - - - - - - - - - - - - - - - - - - To UNSUBSCRIBE please visit:
>http://mailman.qth.net/mailman/listinfo/dxbase