[DXBase] 756 Pro II radio control problems with DXBase 2004
Jack
[email protected]
2003年5月25日 22:53:17 -0400
Thanks Jason. Yes, in 2004, we added RTS high/low as a user option because
some folks wanted to use the RTS for PTT keying. Apparently the ICOMs need
to have RTS set high while the Yaesu's don't care, and Kenwood ... well not
sure. In any case, if you wanted the radio interface to be like 2003, just
set RTS on with a check mark in user options.
Cheers,
Jack
----- Original Message -----
From: "Jason Amos (KD4BJW)" <[email protected]>
To: <[email protected]>
Sent: Sunday, May 25, 2003 10:36 PM
Subject: [DXBase] 756 Pro II radio control problems with DXBase 2004
> Just wanted to post to everyone that I had no problems communicating with
> my 756 Pro II with 2003 version. I was reading back over the archives
> trying to hunt down any information that could help me out. I found in an
> April archive titled Radio Control that Greg Tomerlin solved someone
else's
> problem by telling them to select the DTR and RTS be on. He had done that
> on his 746. I tried it with them both on and it now works.
>> In 2003 you can only select DTR to be on. I am assuming that 2003 always
> asserted RTS. Anyway the ICOM converter that I am using to go from the
> RS-232 to CI-V interface requires power from RTS. That is why it was not
> working. Hope this helps someone else.
>> 73,
>> Jason Amos
> KD4BJW
>>> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase