[DXBase] Lost CW functionality in Dxbase 2004
Michael L. Therrien, MD
[email protected]
Tue, 8 Jul 2003 07:04:24 -0400
Set up Dxbase 2004 last night. Had Dxbase 2002 running fine. Same
machine, same ports.
I cannot get CW from LPT 1. COM ports seem to act OK, though the rotor
on COM 3 has a problem not seen in Dxbase 2002. Commanding the rotor to
move creates a situation where the whole machine freezes for 60-90 sec
then the rotor moves to the correct position and the program resumes.
I have used the driver update program and verified the ports in Control
Panel.
Any ideas what I should do next?
BTW I still have Dxbase 2002 in a separate directory from 2004. Is this
OK? Might it create conflicts of some type?
Tnx
Mike, N1MD
Michael L. Therrien, MD, MMM, CPE
Amateur Radio Station N1MD
"Primum non nocere"