[DXBase] Label printing: specifying starting location on
label sheet
Garth A. Hamilton - VE3HO
[email protected]
2003年2月03日 08:30:35 -0500
When you select your label on the next screen to appear on the left side there is a select window with an arrow on the right side click the arrow and select preview. Now below this window right above the boxes labeled start and close is a multi form icon and if you click on that a default page will show with the label format showing a default start by highlighting of the top left label. With your mouse left click on the label where you want printing to start. Click OK and then START and the preview screen will show you the page with the labels starting with the one you selected. On the printer icons on top of the page the left hand one will print a single page and the right hand one will print until all entries in the print que are printed.
Hope this helps
73 Garth VE3HO
At 08:59 PM 02.02.2003 -0800, Richard Karlquist wrote:
>I would like to print labels on 5161 label
>sheets, which have 20 labels per sheet. If
>I print less than 20 labels, then I have a
>partial sheet left over. If I want to use
>up this sheet, I need to get the printer
>to start at the first unused label. Is there
>a way to tell DXBase to do this? The only
>way I can figure out to do it would be to
>create 20 versions of the label design, with
>the starting position hardwired in. Then
>I would select the correct version for the
>number of labels remaining on the sheet.
>>This seems like it would be a common problem,
>but I see no mention of it. Does everyone
>just print in batches of 20?
>>Rick Karlquist N6RK
>[email protected]
>www.n6rk.com
>www.karlquist.com
>_______________________________________________
>DXBase Reflector - Please visit us on the web at www.dxbase.com
>- - - - - - - - - - - - - - - - - - - - - - -
>To UNSUBSCRIBE please visit:
>http://mailman.qth.net/mailman/listinfo/dxbase