[DXBase] TNC INIT
Rick Kourey
[email protected]
Sat, 1 Feb 2003 10:03:12 -0500
Mark,
If I understand your question correctly, I have used DXBase with both the
AEA PK-900 and the Kenwood D700 packet transceiver with no special commands.
Other than identify port and stop bits (basic setup) that is it. It works
flawlessly on both units with no special commands or setup.
Rick, K4KL
----- Original Message -----
From: "Mark Shelton" <[email protected]>
To: <[email protected]>
Sent: Saturday, February 01, 2003 2:40 AM
Subject: [DXBase] TNC INIT
> I have an old AEA PK-900 dual-port TNC. In order for me to use it with any
> third party software like DXbase, I need to set it up with a series of
> commands to get it into a single port mode. Is there anyway DXbase can
send
> a set of user defined commands to my TNC when I start the program like
> WriteLog can do via an ini file?
>> Thanks,
>> Mark, K0MS
>>> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
> text/plain (text body -- kept)
> text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment. Attachments are not allowed. To learn how
> to post in Plain-Text go to: http://www.expita.com/nomime.html ---
> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase
>