[DXBase] CW port still not working
Matt Finlayson
[email protected]
2002年11月26日 22:29:35 -0600
Hi Marty,
I use a laptop to run DXBase and my rig. Since I only have one serial port,
I use that to run the rig. I use the parallel port for CW. I paid 25ドル for a
CW-interface cable that goes from the parallel port to the key jack on my
radio. Works fine.
73, Matt K9KRY
----- Original Message -----
From: "Marty Ray" <[email protected]>
To: <[email protected]>
Sent: Monday, November 25, 2002 6:15 PM
Subject: [DXBase] CW port still not working
> I have been trying to get the cw port working for a couple of weeks. I am
> running windows XP, so I am using DTR on my radio serial port. (The help
> file states "DXbase allows you to use the same serial port for CW that is
> used for your TNC or HF radio provided it does not use the DTR leads.")
When
> I set "default DTR High" on the radio port settings, my radio keys up,
which
> is correct. However, whe I try to send CW, I get nothing.
>> I have tried setting the com port address in the driver using 'regedit' to
> no avail. When I look at my com port address in my system\hardware\device
> manger\com4\resources, it shows "I/O range C400-C407" and "IRQ17", so I
set
> the com4 data in regedit as follows:
> "SYSTEM\CurrentControlSet\Services\DriverX\Parameters\Dxb98 COM4\ Port
Base
> 0x0000c400 (50176)"
>> PortCount says "0x00000007 (7)"
>> (Default) says "(value ot set)"
>> and IgnoreConflicts says "0x00000001 (1)"
>> Does anybody have any suggestions. I operate primarily CW, so this
> limitation may be enough for me to look at another logging program.
>> Thanks for any assistance!
>> Regards,
>> Marty Ray N9SE
>>> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase
>