[DXBase] two problems

2002年6月08日 22:35:26 -0400

Hi, Just printing out a batch of QSL's using 5160's/1 QSO.
Found I'd not put my name in "Label Signature" so went and added that.
Now print my label project and it adds "73 de Ray" to abt a third of the
labels.
So close DXbase 2003 and reboot.
Reprint label project and same results. This is wasting a lot of labels
and I'd
like to know what I'm doing wrong.
Any suggestions?
Next problem
I have rotor control when I choose "Enter Degrees" but not when I click
on the Short Path or Long Path. This happens even when I have DX Base 03
set the initial rotor position.
This has only been a problem with the '03 version of DXbase, the '02
version didn't
have this problem.
Thanks
Ray / W1RWB