[DXBase] cw keying - update

2002年12月31日 07:27:08 -0600

Phil
I bet you haven't checked the I/O address of the com port you selected for
cw keying.
Do that in Device Manager, ports, resources.
Then go to the Registry, Find the DriverX keys and make sure that the
address is the same as in the device manager.
This info can be found in the Help File under CW.
This is the MOST common cause for DXB unable to send cw but other programs
work properly.
DXB.
----- Original Message ----- 
From: "Phil ON4VP" <[email protected]>
To: <[email protected]>
Sent: Monday, December 30, 2002 11:13 PM
Subject: [DXBase] cw keying - update
Jack,
I promised to get back with more info.
I installed a fresh copy of DXBase 2003 on a W98SE machine.
PIII/1000MHZ - 521 MB RAM - KEYER COM 1
Keyer is a simple transistor that uses DTR to key rig.
Also on the fresh installed DXBase setting internal keyer to com1 this
function do not work.
I've tested the keyer, works great on f.e. MixW 206, N1MM logger, ...
To be shure, I installed W98SE, than DXBase 2003, then tested, then after
having no results installed additional software so no 3th party drivers
where involved.
So I think I've done everything by the book.
Since there's no way to set the pin number high (like RTS, DRT, etc...) in
the setup I'm not shure what is going wrong, but can't get this thing to
work.
WHat I find strange is that the same small transistor based keyer function
well on other packages, and I don't think in W98 there are additional
drivers installed anyhow ...
Best 73
Phil ON4VP
--- StripMime Report -- processed MIME parts ---
multipart/alternative
 text/plain (text body -- kept)
 text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---
_______________________________________________
DXBase Reflector - Please visit us on the web at www.dxbase.com
- - - - - - - - - - - - - - - - - - - - - - -
To UNSUBSCRIBE please visit:
http://mailman.qth.net/mailman/listinfo/dxbase