[DXBase] JUST a undocumented tip

2002年12月12日 17:28:59 -0600

I assign different characters to my label Groups.
for example.
P5/4L4FN were given P
BS7XX was given B
You can do this from inside the Pending QSL window by overwriting any
default.
Basically I've been able to use any Uppercase letter, and even Symbols such
as #, &.
I do this usually in the case of Dxpeditions and then can print all the
qsl's when the operation is over.
I also assign the same character to the qsl route.
I've found you can print a number of groups at the same time.
When you select qsl's to print and you get that Group box.
you can type in the Upper Case letters, or number/symbols you want.
And you can do multiples.
In the above example
I entered P B. just separate them with a space.
I've never experimented to see how many different groups I could print at
the same time.
And lower case characters don't seem to work for me.
Also you can delete printed groups by putting all the Group Characters into
the 'Delete QSO/Addresses' boxes. Again separate with a space.
Anybody have any similar tips?
-----------------------------------------------------
I'm a internaut and I'm OK. I surf all night and I sleep all day.
-----------------------------------------------------
Bill H. in Chicagoland