The official source: http://www.yaesu.com/indexVS.cfm?cmd=DisplayProducts&ProdCatID=104&encProdID =75EAFAA323C271AB4E2C8359D4450039&DivisionID=65 another source for the older sdx versions: http://www.radiomanual.info/schemi/ACC_rotator/Yaesu_G-800S_SDX_G-1000S_SDX_ user.pdf David Robbins K1TTT e-mail: mailto:k1ttt at arrl.net web: http://wiki.k1ttt.net AR-Cluster node: 145.69MHz or telnet://k1ttt.net -----Original Message----- From: Antennas [mailto:antennas-bounces at mailman.qth.net] On Behalf Of Larry Sent: Friday, December 12, 2014 20:44 To: antennas at mailman.qth.net Subject: [Antennas] Yaesu G-800S rotator I don't know if this is a relative subject here or not so if not, please let me know who or where i might find relative info. MY Yaesu G-800S rotator quit working this morning. I found a brown wire had become un-attached from somewhere on the main board that turns the indicator. I don't see any likely place where it could have been attached. The end of the wire is slightly spread but all other wires on the board are soldered which leads me to think that this may have been a poor solder point. However, i have no schematic or wiring infor for this item so my request is does anyone know where such an animal can be found. Somewhere in the past i recall reading a blurb to the effect that Yaesu essentially did no support for their rotators. Any help? Larry W0OGH ______________________________________________________________ Antennas mailing list Home: http://mailman.qth.net/mailman/listinfo/antennas Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Antennas at mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html