[Antennas] resonance

fkamp at comcast.net fkamp at comcast.net
Sat Dec 17 11:47:55 EST 2005


David Robbins K1TTT wrote:
> Yes, if you are tuned to resonance the impedance at the
> antenna will be purely resistive. And yes that impedance
> value can change as you vary the height of an antenna...

Yes, I have seen that happen, but does the impedance remain 
purely resistive as its value changes with height variation? 
 And is a purely resistive impedance the only measure of 
resonance. (Please no cracks about dummy loads being 
resonant at ALL frequencies).
> to further confuse things, the change in height can also
> change the frequency where the antenna is resonant. So
> if you have an antenna 1/4 wave up tuned to resonance at
> 7000khz with an impedance of 75 ohms and move it higher
> the resonant point may move to 7150khz and the impedance
> at 7150 may be 70 ohms.

Have you actually experienced this? I mean acutally seen 
this happen on an antenna you installed? I dont understand 
why a height change would have an effect on frequency AND 
impedance AND resonance. The chart in the handbook shows a 
definate variation in impedance with height change but no 
change in frequency.
Regards,
Frank Kamp
>>> David Robbins K1TTT e-mail: mailto:k1ttt at arrl.net web:
> http://www.k1ttt.net AR-Cluster node: 145.69MHz or
> telnet://dxc.k1ttt.net
>>>>> -----Original Message----- From:
>> antennas-bounces at mailman.qth.net [mailto:antennas- 
>> bounces at mailman.qth.net] On Behalf Of fkamp at comcast.net
>> Sent: Saturday, December 17, 2005 15:56 To:
>> antennas at mailman.qth.net Subject: [Antennas] resonance
>>>> I may not understand all I think I know about
>> resonance.
>>>> Take the case of a dipole antenna.
>>>> Resonance is where the impedance becomes resistive when
>> the length is cut to the desired frequency. If the
>> dipole is flat-topped at 1/4 wavelength above
>> electrical ground, that resistive impedance is 75 ohms.
>>>>>> That is what I know. Is that all there is to it?
>>>> What happens when the dipole is not 1/4 wavelength
>> above electrical ground. A chart in the handbook
>> indicates that under those conditions the impedance can
>> vary significantly from 75 ohms.
>>>> My question is does the impedance remain resisitive as
>> the height above ground is varied and the impedance
>> changes?
>>>> Regards, Frank Kamp K5DKZ 
>> ______________________________________________________________
>> Antennas mailing list Home:
>> http://mailman.qth.net/mailman/listinfo/antennas Help:
>> http://mailman.qth.net/mmfaq.html Post:
>> mailto:Antennas at mailman.qth.net
>>>> ______________________________________________________________
> Antennas mailing list Home:
> http://mailman.qth.net/mailman/listinfo/antennas Help:
> http://mailman.qth.net/mmfaq.html Post:
> mailto:Antennas at mailman.qth.net
>


More information about the Antennas mailing list

AltStyle によって変換されたページ (->オリジナル) /