[Antennas] All You Ever Wanted To Know About A Hustler 5-BTV Vertical !
George, W5YR
[email protected]
2003年2月27日 00:11:29 -0600
I'm with you, Dan and that bright red wire sounds great! I need to replace
my radial field this Spring and red wire for a change might look great. Of
course, in a couple of months the Bermuda will cover it but it will be nice
until then.
73/72, George
Amateur Radio W5YR - the Yellow Rose of Texas
Fairview, TX 30 mi NE of Dallas in Collin county EM13QE
"In the 57th year and it just keeps getting better!"
-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of W1GOR
Sent: Wednesday, February 26, 2003 8:39 PM
To: [email protected]
Subject: Re: [Antennas] All You Ever Wanted To Know About A Hustler
5-BTV Vertical !
Dan,
The installation instructions for the 4, 5, and 6-BTV antennas specify fully
insulated radials. The best way to accomplish this, is to bury insulated
wire and seal the outer end. Liquid insulation works very well. I've got
a 6-BTV and installed 4 radials per band. Each radial is made of insulated
14 AWG stranded wire. I chose a bright red wire that will show up well
against the green grass... Up here in Maine, frost heave occasionally
causes shallow-buried radials to creep to the surface during the spring
thaw. So far, I've avoided running over the red radials with my ride-on
lawnmower...
73, Larry - W1GOR
----- Original Message -----
From: "Dan Richardson" <[email protected]>
To: "Don Schaefer" <[email protected]>; < >
Sent: Wednesday, February 26, 2003 3:31 PM
Subject: Re: [Antennas] All You Ever Wanted To Know About A Hustler 5-BTV
Vertical !
> At 12:15 AM 2/26/2003 -0600, Don wrote:
> [snip]
>> >You can make the 5-BTV work with the
> >minimum number listed in the installation instructions, but adding more
> >FULLY INSULATED radials will improve the bandwidth and radiation pattern.
> >Read the instructions and make sure to insulate the outer ends of each
> >radial wire. Home Depot, Sears, Lowes, and most local hardware stores
sell
> >liquid tape, an insulating compound that is available in small cans with
an
> >applicator brush inside the cap. When you make up your radials, simply
dip
> >the outer end in the insulating liquid and let it dry.
>> [snip]
>>>> Don,
>> The majority of your suggestions seem right on the mark, however, there is
> one which I am wondering about. I don't understand in your statement above
> what is gained (antenna operation wise) by covering the radial wires with
> plastic like insulation material.
>>> Danny
> K6MHE
>> No trees were destroyed in the sending of this message.
> However, a large number of electrons were terribly inconvenienced.
>> - - -
>> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
> _______________________________________________
> Antennas mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/antennas
- - -
Your moderator for this list is:
Larry Wilson KE1HZ [email protected]
_______________________________________________
Antennas mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/antennas