USB port on openmoko

Fri May 1 01:45:19 CEST 2009

2009年5月1日 Mark Night <marknight11 at gmail.com>:
> I am doing a project on openmoko. I need some help regarding the usb
> interface of openmoko.
> Is USB port available on openmoko a master, slave or OTG port?

master or slave, switchable manually through software. not otg. there
is a page on the wiki with lots of detail about how to switch it in
software, how to get/make cables, providing/drawing power, etc
http://wiki.openmoko.org/wiki/USB
shows some of them
there are also a couple of apps at opkg.org for switching host/slave;
i'm not sure if they work with the new sysfs paths, though
> I need to send the data from openmoko to an embedded device through a usb to
> serial converter IC. The small embedded device only has facility for serial
> data transfer (USART). So, how can I send some data from openmoko through C
> code or any other utility by which the data can be converted to serial
> format by that IC and then can be received by the  embedded device.
> Any help will be highly appreciated as the project is related to my course
> at university.
> Thanks...