[WriteLog] Anyone using FT9000 with Writelog?

Tue Jun 27 08:44:42 EDT 2006

Try turning off "Transceiver Mode" in the comm port settings on the radio.
Mike, W1NR
----- Original Message ----- 
From: "miles" <miles at milarasmt.com>
To: <writelog at contesting.com>
Sent: Tuesday, June 27, 2006 7:51 AM
Subject: [WriteLog] Anyone using FT9000 with Writelog?
>> Here are some issues that I have.
> Has anyone else seen similar.
> Thanks,
> Miles
>>> Serial drop
>> At any baud rate, the serial link between writelog and the Ft9000 drops 
> "No
> Radio" shows up on the display.
>> I have tried all baud rates from 4800 - 9600.
>> The cable is a stock 9 pin serial.
>> The link only stays up for a short time then drops.
>>>> Split light.
>> Frequency when changing frequency by clicking on Spots or the Freq GUI 
> bars,
> the Split light on the 9000 keeps coming on.
>> I keep manually shutting off split, but it keeps coming back on.
>>>> Freq Gui bars.
>> When I click on a vfo gui bar, it will load the freq into the Primary
> display.
>> Is there any way to use these as just a way toggle between the two a/b
> vfo's.
>> If VFO A is the primary and I click on the gui for vfo B, it will load VFO 
> A
> with the values from the gui B.
>> I end up with both vfo A and B the same freq. What I would prefer is to
> click on Gui A to become the primary or click B to become the primary, 
> not
> rewrite the primary, just toggle between the two.
>>>>>> Any input will be helpful full
>> Thanks, Miles
>> om/
>> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>